[clos] belkin f5d8053 Interface doesn't support scanning Network is...

jajaX · Le 14/11/2010, à 01:23

bonjour,

une amie, sous ubuntu, ayant un soucis avec sa connexion filaire, je lui ai acheté une clé usb wifi pour la remplacer. mais ça coince

la clé usb wifi est une belkin f5d8053 v6.
elle avait, initialement la 9.10 mais ça marchais déjà pas, j'ai fait les mises à jour vers la 10.04 et ensuite 10.10.

voici les infos habituelles =>

cat /etc/lsb-release
DISTRIB_ID=Ubuntu
DISTRIB_RELEASE=10.10
DISTRIB_CODENAME=maverick
DISTRIB_DESCRIPTION="Ubuntu 10.10"

lsusb
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 002: ID 050d:815f Belkin Components F5D8053 N Wireless USB Adapter v6000 [Realtek RTL8192SU]
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

lspci
00:00.0 Host bridge: VIA Technologies, Inc. VT8377 [KT400/KT600 AGP] Host Bridge (rev 80)
00:01.0 PCI bridge: VIA Technologies, Inc. VT8237/VX700 PCI Bridge
00:0f.0 RAID bus controller: VIA Technologies, Inc. VIA VT6420 SATA RAID Controller (rev 80)
00:0f.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 81)
00:10.4 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 86)
00:11.0 ISA bridge: VIA Technologies, Inc. VT8237 ISA bridge [KT600/K8T800/K8T890 South]
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233/A/8235/8237 AC97 Audio Controller (rev 60)
00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 78)
01:00.0 VGA compatible controller: nVidia Corporation NV44A [GeForce 6200] (rev a1)

lspci -nn | grep -i net
00:12.0 Ethernet controller [0200]: VIA Technologies, Inc. VT6102 [Rhine-II] [1106:3065] (rev 78)

sudo lshw -C network
[sudo] password for sylvie: 
  *-network               
       description: Ethernet interface
       product: VT6102 [Rhine-II]
       vendor: VIA Technologies, Inc.
       physical id: 12
       bus info: pci@0000:00:12.0
       logical name: eth0
       version: 78
       serial: 00:0b:6a:bc:e6:52
       size: 100MB/s
       capacity: 100MB/s
       width: 32 bits
       clock: 33MHz
       capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=via-rhine driverversion=1.4.3 duplex=full ip=192.168.1.98 latency=32 link=yes maxlatency=8 mingnt=3 multicast=yes port=MII speed=100MB/s
       resources: irq:23 ioport:c000(size=256) memory:dfffbd00-dfffbdff
  *-network DISABLED
       description: Wireless interface
       physical id: 1
       logical name: wlan1
       serial: 00:22:75:ab:00:59
       capabilities: ethernet physical wireless
       configuration: broadcast=yes multicast=yes wireless=802.11b/g

lsmod
Module                  Size  Used by
binfmt_misc             6599  1 
nvidia               9329739  38 
snd_via82xx            20140  2 
snd_ac97_codec         99227  1 snd_via82xx
ac97_bus                1014  1 snd_ac97_codec
snd_pcm                71475  2 snd_via82xx,snd_ac97_codec
snd_page_alloc          7120  2 snd_via82xx,snd_pcm
snd_mpu401_uart         5661  1 snd_via82xx
snd_seq_midi            4588  0 
snd_rawmidi            17783  2 snd_mpu401_uart,snd_seq_midi
r8192s_usb            287340  0 
snd_seq_midi_event      6047  1 snd_seq_midi
snd_seq                47174  2 snd_seq_midi,snd_seq_midi_event
via_agp                 5322  1 
ppdev                   5556  0 
ns558                   3068  0 
i2c_viapro              5777  0 
gameport                9327  3 snd_via82xx,ns558
eeprom_93cx6            1345  1 r8192s_usb
snd_timer              19067  2 snd_pcm,snd_seq
parport_pc             26058  1 
lp                      7342  0 
agpgart                32011  2 nvidia,via_agp
psmouse                59033  0 
shpchp                 29886  0 
serio_raw               4022  0 
snd_seq_device          5744  3 snd_seq_midi,snd_rawmidi,snd_seq
snd                    49006  12 snd_via82xx,snd_ac97_codec,snd_pcm,snd_mpu401_uart,snd_rawmidi,snd_seq,snd_timer,snd_seq_device
soundcore                880  1 snd
parport                31492  3 ppdev,parport_pc,lp
via_rhine              19038  0 
pata_via                7300  6 
sata_via                7344  0 
floppy                 54311  0 
mii                     4425  1 via_rhine

iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wlan1     802.11b/g  ESSID:"g\xC6isQ\xFFJ\xEC)\xCD\xBA\xAB\xF2\xFB\xE3F|\xC2T\xF8\x1B\xE8\xE7\x8DvZ.c3\x9F\xC9\x9A"  
          Mode:Managed  Access Point: Not-Associated   Bit Rate:0 kb/s   
          Retry min limit:7   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=0/100  Signal level=0 dBm  Noise level=0 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

ifconfig
eth0      Link encap:Ethernet  HWaddr 00:0b:6a:bc:e6:52  
          inet adr:192.168.1.98  Bcast:192.168.1.255  Masque:255.255.255.0
          adr inet6: fe80::20b:6aff:febc:e652/64 Scope:Lien
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          Packets reçus:14514 erreurs:0 :0 overruns:0 frame:0
          TX packets:9968 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 lg file transmission:1000 
          Octets reçus:19170614 (19.1 MB) Octets transmis:1067769 (1.0 MB)
          Interruption:23 Adresse de base:0x8d00 

lo        Link encap:Boucle locale  
          inet adr:127.0.0.1  Masque:255.0.0.0
          adr inet6: ::1/128 Scope:Hôte
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          Packets reçus:374 erreurs:0 :0 overruns:0 frame:0
          TX packets:374 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 lg file transmission:0 
          Octets reçus:21414 (21.4 KB) Octets transmis:21414 (21.4 KB)

sudo iwlist scan
lo        Interface doesn't support scanning.

eth0      Interface doesn't support scanning.

wlan1     Interface doesn't support scanning : Network is down

uname -r -m 
2.6.35-22-generic i686

cat  /etc/network/interfaces
auto lo
iface lo inet loopback
#auto wlan0

nm-tool

NetworkManager Tool

State: connected

- Device: wlan1 ----------------------------------------------------------------
  Type:              802.11 WiFi
  Driver:            rtl819xU
  State:             disconnected
  Default:           no
  HW Address:        00:22:75:AB:00:59

  Capabilities:

  Wireless Properties
    WEP Encryption:  yes
    WPA Encryption:  yes
    WPA2 Encryption: yes

  Wireless Access Points 


- Device: eth0  [Auto eth0] ----------------------------------------------------
  Type:              Wired
  Driver:            via-rhine
  State:             connected
  Default:           yes
  HW Address:        00:0B:6A:BC:E6:52

  Capabilities:
    Carrier Detect:  yes
    Speed:           100 Mb/s

  Wired Properties
    Carrier:         on

  IPv4 Settings:
    Address:         192.168.1.98
    Prefix:          24 (255.255.255.0)
    Gateway:         192.168.1.1

    DNS:             192.168.1.1

comme vous pouvez le voir la carte est "down" ! et d'ailleurs son voyant ne s'allume pas.
j'ai fait quelques recherches et tests dans résultats pour le moment.

j'ai trouvé cette page mais cela concerne karmic.possible qu'il faille faire la même chose sous maverick. j'ai aussi trouvé ça.

merci de votre aide.

edit : et la connexion filaire fonctionne très bien chez moi... mais bon c'est une autre histoire...

Dernière modification par jajaX (Le 16/11/2010, à 00:04)

jajaX · Le 16/11/2010, à 00:02

bon j'ai essayé la méthode de la page mais la compilation échoue même pour la version plus ancienne pour karmic (voir la doc). ndiswrapper n'a rien donné non plus. je laisse tomber et je vais me faire changer la clé...

Ubuntu-fr

Navigation

Liens de recherche

Annonce

#1 Le 14/11/2010, à 01:23

[clos] belkin f5d8053 Interface doesn't support scanning Network is...

#2 Le 16/11/2010, à 00:02

Re : [clos] belkin f5d8053 Interface doesn't support scanning Network is...

Pied de page des forums